Skip to Content
Last modified by sndueste on 2025-09-08 15:36
From version 13.1
edited by sndueste
on 2019-10-24 16:26
Change comment: There is no comment for this version
To version 11.1
edited by sndueste
on 2019-10-24 09:30
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -237,23 +237,11 @@
237 237  Few things to consider (in case of doubt talk to the expert (Erland ...)):
238 238  
239 239  * 1000 MB: This is the standard setting which is best for archiving (few large files are preferred). However mainly for images that are saved with less than 10 Hz the HDF5 converter has problems with the large files. And for low data rates it may take upto half an hour to fill one 1GB file. Then smaller ones are also preferable.
240 -* 350 MB: Often a good compromise ...
241 -* 100 MB: It is not preferred to have many "small" files for storing the data. For very small data rates this is an option to not wait too long till the next file is created.
242 242  
243 -To choose the desired filesize one has to choose a run mode configuration in the RunControlGUI
241 +Basically it is
244 244  
245 -[[image:attach:image2019-10-24_15-29-36.png||height="400"]]
246 -
247 -This will however the clear the definition of selected subsystems and one has to reload the whitelist of the experiment again:
248 -
249 -[[image:attach:image2019-10-24_15-32-5.png||thumbnail="true" height="250"]]
250 -
251 251  \\
252 252  
253 -\\
254 -
255 -\\
256 -
257 257  === Assigning the DAQ to the beamline in jddd ===
258 258  
259 259  To assign which DAQ is used at what beamline one has to use the dropdown menu in the {{code language="none"}}parameter monitor{{/code}}. In each Beamline overview tab (BL1,2,3) there is a button (upper right) that starts the {{code language="none"}}parameter monitor{{/code}} panel. In the upper middle is a DAQ field in which the appropriate DAQ can be assigned to the Beamline.
... ... @@ -365,9 +365,9 @@
365 365  \\
366 366  
367 367  *
368 -** one has to go to the "Run Modes" tab and select the run mode {{code language="none"}}FLASH1_EXP{{/code}} by clicking on it and choose the desired file size (stored settings)
369 -[[image:attach:image2019-10-24_15-29-36.png||height="400"]]
370 -** then one has to go back to the {{code language="none"}}Subsystems{{/code}} . initially all subsystems are included.
356 +** one has to go to the "Run Modes" tab and select the run mode {{code language="none"}}FLASH1_EXP{{/code}} by clicking on it !
357 +[[~[~[image:url:http://hasfweb.desy.de/pub/Setup/DAQjddd/runmode_set.jpg~|~|alt="runmode_set.jpg" width="400" height="400"~]~]>>attach:runmode_set.jpg]]
358 +** then one has to go back to the {{code language="none"}}Subsystems{{/code}} . now all subsystems are included.
371 371  ** finally you have to select your White list and start a run ...
372 372  
373 373  \\