Skip to Content
Last modified by sndueste on 2025-09-08 15:36
From version 28.1
edited by sndueste
on 2022-09-08 11:18
Change comment: There is no comment for this version
To version 29.1
edited by sndueste
on 2022-09-08 17:33
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -225,7 +225,7 @@
225 225  
226 226  === Load/Save the configuration ===
227 227  
228 -[[image:attach:whitelist.jpg||height="400"]]
228 +[[image:attach:whitelist.jpg||height="250"]]
229 229  
230 230  Once a list of subsystems is defined and tested this parameter combination should then be saved in a so-called //white list//. By loading this white list one can then easily configure the DAQ after changes / restarts ... to the initially defined settings to save the correct data.
231 231  The whitelist can be saved/loaded with the Run Control GUI by: {{code language="none"}}File -> Group White List -> Save/Load{{/code}}. Note, while the top left rectangle's background of time and date is yellow, don't try any further controls of the GUI, you might confuse the program. It is busy reading the configuration from the run control database. The background changes back to grey when it has finished.
... ... @@ -286,7 +286,7 @@
286 286  
287 287  === No //START// or //STOP// buttons are visible in the DAQ control panel ===
288 288  
289 -~* The jddd GUI only shows the Start and stop button if the DAQ is in the "Idle" state. sometimes the DAQ "just" gets stuck in the stopping phase. Then stopping again or starting form the not "Idle" state can help. For this goto the "Advanced" tab of the jddd DAQ control . there the START and STOP buttons are always available ... independent of the state of the DAQ. If this does not help you may have to restart the DAQ ...
289 +The jddd GUI only shows the Start and stop button if the DAQ is in the "Idle" state. Sometimes the DAQ "just" gets stuck in the stopping phase. Then stopping again or starting form the not "Idle" state can help. For this goto the "Advanced" tab of the jddd DAQ control . there the START and STOP buttons are always available ... independent of the state of the DAQ. If this does not help you may have to restart the DAQ ...
290 290  
291 291  \\
292 292