Skip to Content
Last modified by sndueste on 2025-09-08 15:36
From version 9.1
edited by sndueste
on 2019-09-18 16:46
Change comment: There is no comment for this version
To version 11.1
edited by sndueste
on 2019-10-24 09:30
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -214,10 +214,6 @@
214 214  
215 215  \\
216 216  
217 -\\
218 -
219 -\\
220 -
221 221  === Load/Save the configuration ===
222 222  
223 223  
... ... @@ -232,20 +232,24 @@
232 232  
233 233  \\
234 234  
235 -\\
231 +=== Choosing the file size ===
236 236  
237 -\\
233 +The DAQ writes into a file (in .raw format) up to a configurable value. If the limit is reached the file will be closed and a new file will be started. Thus a run can contain tens to hundreds of files.
238 238  
239 -=== Assigning the DAQ to the beamline in jddd ===
235 +The size can be configured to be 100 MB, 350 MB or 1000 MB (default)
240 240  
241 -To assign which DAQ is used at what beamline one has to use the dropdown menu in the {{code language="none"}}parameter monitor{{/code}}. In each Beamline overview tab (BL1,2,3) there is a button (upper right) that starts the {{code language="none"}}parameter monitor{{/code}} panel. In the upper middle is a DAQ field in which the appropriate DAQ can be assigned to the Beamline.
237 +Few things to consider (in case of doubt talk to the expert (Erland ...)):
242 242  
243 -\\
239 +* 1000 MB: This is the standard setting which is best for archiving (few large files are preferred). However mainly for images that are saved with less than 10 Hz the HDF5 converter has problems with the large files. And for low data rates it may take upto half an hour to fill one 1GB file. Then smaller ones are also preferable.
244 244  
245 -\\
241 +Basically it is
246 246  
247 247  \\
248 248  
245 +=== Assigning the DAQ to the beamline in jddd ===
246 +
247 +To assign which DAQ is used at what beamline one has to use the dropdown menu in the {{code language="none"}}parameter monitor{{/code}}. In each Beamline overview tab (BL1,2,3) there is a button (upper right) that starts the {{code language="none"}}parameter monitor{{/code}} panel. In the upper middle is a DAQ field in which the appropriate DAQ can be assigned to the Beamline.
248 +
249 249  \\
250 250  
251 251  === Setting the logbook to print in / putting the Whitelist name in jddd ===
... ... @@ -366,12 +366,8 @@
366 366  
367 367  \\
368 368  
369 -=== what else ??? ===
370 -
371 371  \\
372 372  
373 -\\
374 -
375 375  ----
376 376  
377 377  [[Some more details for experts ...>>doc:FLASH.Collection of Detailsof the DAQ from various times \.\.\. not for public use]]